After 8 years of loyal service, my KA engine finally let go. It lost coolant pressure during ECB Hot Laps and melted down. After disassembly, I found a torn hose under the intake manifold. I am eliminating those factory hoses and am now installing a fresh engine to go another 8 years!!!

72
1567


After 8 years of loyal service, my KA engine finally let go. It lost coolant pressure during ECB Hot Laps and melted down. After disassembly, I found a torn hose under the intake manifold. I am eliminating those factory hoses and am now installing a fresh engine to go another 8 years!!!

72 comments

  1. the_real_legg profile image
    the_real_legg 30 May, 2017 at 16:02 Reply

    Just goes to show how stout ka24de really is, everyone calls them trash but 8 years on stock block getting abused, and it only let go because of a coolant hose blowing, probably would have lasted much longer

  2. cool_it_bob profile image
    cool_it_bob 30 May, 2017 at 16:05 Reply

    After taking a picture with you, sorry I caught you at a bad time, but I did see your coolant spray up a foot and a half above your block at ECB, to the best of luck on your next motor. 🏽

  3. the_real_legg profile image
    the_real_legg 30 May, 2017 at 16:36 Reply

    Haha sweet, makes me even more excited for my fully built ka build im doing rn, can’t wait to be busting on sr’s in my “inferior truck” engine as some say

  4. iproton profile image
    iproton 30 May, 2017 at 16:55 Reply

    @chrisforsberg64 I was asking cause I am curious myself. I need to swap my hoses all around, figured you’d point me in the right direction about the materials, cause changing them every few years doesn’t sound very fun to me.

  5. nismos13.5 profile image
    nismos13.5 30 May, 2017 at 17:09 Reply

    @chrisforsberg64 I just had the same problem on my rb25 except luckily it was just a pinhole in one of those same under the intake coolant lines and I smelt the coolant so wasn’t fatal.. still had the Nissan emblem on the hose.. it’s funny how much stuff like that is over looked

  6. nathanbeake profile image
    nathanbeake 30 May, 2017 at 17:36 Reply

    @chrisforsberg64 could you elaborate on what injectors, computer etc you run. I know it’s a DOC manifold. Mishi oil cooler and other cooling components. I remember the old walk around video you made for it but wondering if we could get more details. Maybe a garage day video with you where you get real technical on your builds. Get @donutmedia on the case? C’mooooooooonnnnnnn

Leave a reply

More News

downloadfilmterbaru.xyz nomortogel.xyz malayporntube.xyz