ad

Announcement

Collapse
No announcement yet.

FC JDM RHD Front Clip 1991 TurboII ($2500.00)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • FC JDM RHD Front Clip 1991 TurboII ($2500.00)

    $2500.00 for it and i can ship it


    FC3S 1991 Mazda RX7 Turbo Series 5, white (128,640 km / 79,757 miles)

    -Complete late type front body
    -chin spoiler / lip
    -dark housing front lens (under the headlights / above the blinkers)
    -Complete engine bay
    -13B-T late type, series 5 engine setup
    -ECU + wiring harness
    -5 speed manual transmission
    -OEM intake box
    -aftermarket alternator pulley kit
    -"Blitz" spark plug wires
    -Complete dash kit in good condition
    -all pedal assemblies (clutch, brake, and accelerator)
    -center console and center bezel
    -wood grain steering wheel w/ adapter
    -center armrest w/ power folding mirror switch
    -"Eunos Roadster" floor mats
    -side folding mirrors
    -OEM springs on all 4 corners
    -"KYB" Climb Gear shocks on all 4 corners
    -"HKS" adjustable camber pillow ball mount kit, purple
    -"Project U (mu)" front brake pads
    -slotted rotors for front
    -rear subframe assembly
    -differential (LSD)
    -disc brake kit
    -parking brake cables
    -driveshafts
    -propeller shaft
    -sway bar kit
    -all suspension arms / beams

    Compression test: 90 psi front, 90 psi rear, tested at a lower rpm (200 range)
    Compression test: 125 psi front, 125 psi rear, tested at a higher rpm (300+ range)
    Mazda compression tester: front 8.9 / 8.9 / 9.2 kPa @ 271 RPM, rear 9.1 / 9.2 / 9.3 kPa @ 270 RPM
    Attached Files

  • #2
    DAMN thats one nice @ss front clip...If only i still had my FC

    Comment


    • #3
      yea it is one of the cleanest i have got

      Comment


      • #4
        bump still have it

        Comment


        • #5
          how much trouble would it be to swap this into a first gen..

          *keep in mind, i know nothing about rotaries.

          Comment


          • #6
            Originally posted by brokenben
            how much trouble would it be to swap this into a first gen..

            *keep in mind, i know nothing about rotaries.
            it takes a little work but it has been done before i think mazdatrix has a write up about what you'll need
            www.mazdatrix.com

            Comment


            • #7
              sold thanks

              Comment

              Working...
              X