FC JDM RHD Front Clip 1991 TurboII ($2500.00)

[SDRotary]

$2500.00 for it and i can ship it


FC3S 1991 Mazda RX7 Turbo Series 5, white (128,640 km / 79,757 miles)

-Complete late type front body
-chin spoiler / lip
-dark housing front lens (under the headlights / above the blinkers)
-Complete engine bay
-13B-T late type, series 5 engine setup
-ECU + wiring harness
-5 speed manual transmission
-OEM intake box
-aftermarket alternator pulley kit
-"Blitz" spark plug wires
-Complete dash kit in good condition
-all pedal assemblies (clutch, brake, and accelerator)
-center console and center bezel
-wood grain steering wheel w/ adapter
-center armrest w/ power folding mirror switch
-"Eunos Roadster" floor mats
-side folding mirrors
-OEM springs on all 4 corners
-"KYB" Climb Gear shocks on all 4 corners
-"HKS" adjustable camber pillow ball mount kit, purple
-"Project U (mu)" front brake pads
-slotted rotors for front
-rear subframe assembly
-differential (LSD)
-disc brake kit
-parking brake cables
-driveshafts
-propeller shaft
-sway bar kit
-all suspension arms / beams

Compression test: 90 psi front, 90 psi rear, tested at a lower rpm (200 range)
Compression test: 125 psi front, 125 psi rear, tested at a higher rpm (300+ range)
Mazda compression tester: front 8.9 / 8.9 / 9.2 kPa @ 271 RPM, rear 9.1 / 9.2 / 9.3 kPa @ 270 RPM

[sochinkyeyes]

DAMN thats one nice @ss front clip...If only i still had my FC

[SDRotary]

yea it is one of the cleanest i have got

[SDRotary]

bump still have it

[brokenben]

how much trouble would it be to swap this into a first gen..

*keep in mind, i know nothing about rotaries.

[SDRotary]

Originally posted by brokenben
how much trouble would it be to swap this into a first gen..

*keep in mind, i know nothing about rotaries.

it takes a little work but it has been done before i think mazdatrix has a write up about what you'll need
www.mazdatrix.com

[SDRotary]

sold thanks