Originally posted by BigGameHit
View Post
Announcement
Collapse
No announcement yet.
Donnie's JAPAN ADVENTURES Thread
Collapse
X
-
yea its been on schedule.. however military members are banned from the area as of right now.. and its looking no better with the quake that happen last night.
Installed Ogura twin plate last night .
A buddy Aaron came over just as I got started at about hmmm 9ish pm. Helped me lower the RB trans. While we were under the car, the earth began to shake again. After things settled we resumed. A-rod had to leave shortly after that to go home. I was bored no power and wanted to finish. I sat there and thought, how could I support the rear of this trans. The was after I laid it across my chest and stomach in attempts to bench press it on. I almost had it but was hard to angle it with my penis. I looked up seen the tunnel a hole and my roll cage. Instantly ran and got my trusty 550 cord. Doubled that *Censored**Censored**Censored**Censored**Censored* up looped it around the transmission. I hoisted it up using my roll cage front bar. About 2 min later I was in. Finish about 5 this morning.
I took the car for a drive and stalled it coming out of my garage hahahahah. *Censored**Censored**Censored**Censored* sounds so good and grabs so so so so hard.
Comment
-
Ah, the 1-inch effect, but in vibration mode. Any mention of snow, people run to the stores to buy all the milk and bread, despite it's only an inch of snow or less on the ground.
Don't get me wrong, a couple of quakes like that would freak me out (I do live on the east, so any ground vibration would be weird no matter how small).
Comment
-
Originally posted by BigGameHit View Posthahaha no doubt.. I am from Baltimore.. Natural Disaster is not something im common with.. but im cool about it.... Historical to say the least. I would not like the earth the shake while im drifting next to a wall though, it might screw up my line.
Comment
-
Might have been sleep lol. Just woke up its like 12pm.. im about to go outside and install my oil cooler and another manifold.. Plus some welding.. lets hope my car is not shaken off the jack stands lol.Last edited by BigGameHit; 04-14-2011, 12:26 PM.
Comment
Comment