If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
As always Simon, you did a good job on the day, and I was amazed that Dorry went well lol. I got 50 mins uncut video and 2 4min edited clips of the day - Josh has them on VHS.
Here is the progress on my Trueno:-
Most of external body assembled, central locking installed, started on 3SGE bottom end - ACl rings dont fit properly! (According to ACL there standard rings are for ACL standard pistons
I have to file my oil ring grooves!
Next step is the powder coating of sump, crossmember and mounts
Comment