ad

Announcement

Collapse
No announcement yet.

need 5sp

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • need 5sp

    any body here know what its gunna take for a aouto to 5sp. conversion for my newest 240? I figure a tranny<duh>,drive shaft,and possibly rear end.

  • #2
    the rear end and drive shaft should be fine. Im fixing to do this my self so i've been reading up on it. You should just need the transmission and the hydrallics to run it. Not tomention the clutch and brake pedal to install. And everything that goes with making those run.

    Comment


    • #3
      thanx pawtna,let me know how it gose. My fiscal policy is will hold be holding me back for a while,btw any one know where i can get ahold of a **CHEAP** ka24 header?

      Comment


      • #4
        Wal*Mart

        Comment


        • #5
          Yahh...I mean no.

          Comment


          • #6
            here's a list. It's really easy to do. Done it a couple times.

            -5 speed brake pedal
            -5 speed clutch pedal
            -clutch fluid reserviour
            -clutch fluid hard lines
            -clutch soft line
            -slave cylinder
            -throw out bearing
            -pilot bearing
            -clutch set
            -flywheel
            -tranny (I hope you remember this one)
            -5 speed harness, or make the auto one fit (easy to figure out)
            -drive shaft (get complete drive shaft, both pieces, don't piece them together from seperate cars)
            -shifter
            -shift boot

            that should be all of it.

            edit: auto and 5-speed use different sive drive shafts on 240s
            Last edited by shutUPandLEARN; 05-13-2004, 01:35 PM.

            Comment


            • #7
              Originally posted by nissanguy_24
              ...drive shaft should be fine...
              Huh?

              Comment


              • #8
                Tacaomatose/Dori Whore

                hey hachi- did driftcentrel send you to spy? j/k ,Dosent the shaft have to be shortened like 1.5 in?

                Comment

                Working...
                X