Tweet
hey guys, i was wondering are the USDM 240 guages compatible with the SR motor???.....dont know if this was asked already, if so, 4give me.....thx 4 ne help
-
-
yes they should be as long as you use the correct year w/ the correct sr equipment -
You need speed sensor from KA tranny for speed to be accurate and the SOHC tach does not work correctly with the SR.Comment
-
The gauge cluster is compatible, but since the SR revs and redlines higher than a KA24 (both SOHC and DOHC) I would reccomend swapping the JDM gauges complete with the motor.Comment
-
but technically you can use the gauges, right? i have a 91 se thats gettting sr finished up this week, so i will be ok, right? the tach goes to 9, so i will just have to know that red is 8, and can make a new face plate for my tach that moves the redline to 8 rather than 7 but use the same tach, right?
*sorry for all the rapid fire questions*Comment
-
yes, just change speed sensor in tranny or you will be putting a km/h signal to a gauge that reads mph.Comment
Comment