what would you goes do if you had a bone stock SR20DET and you had $415??? im aiming for touge (just the engine and performance)
Announcement
Collapse
No announcement yet.
$415
Collapse
X
-
How about some Faken Azenis?
Or better yet, a helmet and harness - you'll need them if you're going to drive touge.
The stock SR20 will give you plenty of power. Touge (and performance in general) is all about power to weight ration and with $400 you could do a huge amount of weight reduction and still have $400.
If you really want to spend money I'd suggest strut tower bars, a cheap set of coilovers (which can be had for $100 on Ebay or www.meganracing.com), and camber plates.
If you really want to spend money on engine performance, buy an exhaust that increases torque. There are a lot of kits out there that will give you +10 hp at 6k rpm but have your torque fizzle out in the 2-3k range, which is vital for hills.
A high flow filter will cost you about $20 at autozone and will most likely fit the stock pipe, or you can get an intake for $100-$150. ABS plastic is preffered over aluminum since ally will transfer heat very easily. A cold air box will also keep the intake charge cool for it's compression.
If you can find a used intercooler for that much, that will also benefit you, buy probably not as much as an intake or exhaust.
If you've never built a touge car you'll quickly find that safety, reliability, weight and suspension are all vastly more important than power.
Good luck in your project and I hope this helps.
-MR
Comment
Comment