If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I installed a ksport hydraulic handbrake that's the same as the CNC staging brake. I disconnected the line going to my rear brakes and hooked it up to the inlet on the handbrake then bought some brakeline and hooked up the outlet on the handbrake to the rear brakes. Bled the system. and now my foot pedal feels soft unless I pump it, then that makes the ebrake hard to pull. and then when I let the foot pedal up and press it back down it feels like it's pulling the handbrake down. What did I do wrong?
I can't find the fitting that goes into the inlet to the ksport ebrake. I went to advanceautoparts and they said it was a 7/16-20 but none has it online. Where did you get your fitting?
Comment